Connect Motherboard To Case

step 1. Connect the power to the motherboard. On an ATX board, the power connector
is one large 20 or 24 wire plug. It is keyed for correct installation. Just plug it in. The board may also require a square, 4pin +12v plug and even a spare 4pin Molex or two. Check your manual to make sure the board is fully powered.
step 2. Connect the CPU fan to the power. Many CPU fans connect to one of the power supply leads. They often, then, provide a pass-through so that you have a connector free for a drive, thereby placing the CPU fan on the circuit to a particular drive. Others have a little 3-pin lead that connects to a small connector on the motherboard itself. Just plug it into the motherboard. The connector is usually labeled CPU_FAN 1, or something to that effect. If your cooling fan uses the 3-pin type and you are following this tutorial to the letter, then this is likely already done.
step 3. Study the case connectors on the motherboard and match them up with case connector wires. The connectors are usually a big block of pins located in the lower section of the board. Some boards label the pins, but it is best to have your manual since it can sometimes be difficult to determine which label goes to which set of pins. If you have a good case, each connector will be labeled to tell you what case feature it leads to. If this isn’t the case, you may have to physically trace the wires back to see what feature it goes to. When connecting, consult the manual for pin 1’s, to make sure each connector is plugged in the right way. Remember, if the particular case feature is not working later, you may only have to turn the connector around on the motherboard. The next steps will walk you through connecting each wire.
step 4. Connect the power switch – On ATX machines, the power switch is connected to the motherboard instead of the power supply itself. Consult your manual. The connector is usually labeled PWR_SW, or maybe just PWR, but you must make this connection. Doing this wrong could cause your system not to start later.
step 5. Connect the reset switch. It can be plugged in any way, just make sure you connect it to the right pins. The pins may be labeled RST or RESET, but it is best to also consult the manual.
step 6. Connect Power LED/ Keylock Switch. Many system cases put these two devices on one 5-pin plug, but if you case does not have a keylock, it will be alone. The motherboard will probably be labeled accordingly. Just plug in the plug. If your system has separate plugs for each, connect them separately.
step 7. Connect the hard drive activity LED. Some come on a 2-pin plug. Others come on a four-pin plug, sometimes only two of the pins actually doing anything. Consult your manual, or play with it until it works. It is usually labeled HDD, HDD_LED, or something like that. If this is attached wrongly, the light may either never come on later or will stay on all the time when the PC is running.
step 8. Connect the PC speaker. Most cases put this onto a 4-wire plug. Just plug it in to the 4 pins on the motherboard. Other cases put the speaker connector on two 1-wire plugs. In this case, plug them into pins 1 and 4. I never could figure out why they did that…
step 9. Double-Check your work, as always. Note that if an LED does not light up, its case connector needs to be flipped 180 degrees.